Hobie Thru Hull Wiring Kit

As described

Exactly what I needed. Plugged my holes right up!

Hobie makes solid products. I used this for my fish finder and it was perfect for my setup. This always a clean looking install and water tight seal. I'd highly recommend this product for anyone needing to drill holes.

Well, not sure if it's fair for me to rate it just a 3 but for me but I can't use it for my needs. I have a Lowrance 5 elite fish finder. The power cables works just fine of course since nothing but wire is hanging off one end. My battery is inside the hull of my kayak. However, the transducer has a connector that is just a tad too large for the tightening screw on the thru hull connector. So for me specifically with the type of FF and thru hull mounting, it won't fit. If I do make a thru hull transducer install, I will have to get another connector.Update* I was able to make the locking nut pass thru the transducer cable. I forced it thru. I looked at the nut after and it did somewhat mess with the threads a little but it was still able to screw in and lock it down. Changing from 3 to 4 stars.

This is an excellent wiring kit from Hobie and it will work on any kayak and boat, not just Hobie's. Simple and easy.

Worked great and went in smooth. Looks professionally done with a DIY price.

These little bungs are great... drill a 1 inch hole and thread the bung into hole with proper gasket to seal your harness.. makes for a nice clean installation

I used this to set up a garmin striker 5 cv on my old town sportsman pdl120. O had to use drill bits and try to drill out some of the holes because almost all of them were either way too big, or way too small.Other than that it seals up good, now. Its tight but if you pull just right you can get more slack or pull slack back inside the hull as needed.