136in Corner Cable Concealer, Large Corner Cord Hider, Wire Covers for Cords, Paintable Corner Cord Cover, Cable Management Channel Cable Raceway for Wall, Floor Baseboard, Ceiling -8 X L17in

This was a great find for holding and hiding a cord underneath a window. It was easy to install sections and the adhesive is holding well with a 14 gauge power cord. The covers can slide or snap in, and these feel high quality. I only needed 2 of the 5 sections so far, but will come back to these if I need more!

These are okay and protect the wire. However, the adhesive is not great, and these will fall off the wall easily.

The ducts themselves are nice and work well in my grey home theatre. However, their double sided sticky tape is horrible. It's come off the wall (removing paint in some spots) as if it adheres differently along its length. And taking the tape off is a pain. Replaced with 3M tape one just one side and it works much better.

This corner cable concealer is wonderful! It was easy to use and gets rid of the ghastly cords hanging down the wall!

I used this to run a power cord up the side of my fireplace. The surface is a little uneven due to the brick work but these tubes are holding in there just fine. It looks much much neater.

Need to hide Network wire. And it looks great. Quality and fit just right.

Great idea of a product, poorly executed. First off, the reason for the low rating: it's nearly impossible to peal off the adhesive cover. The non-stick paper that covers the adhesive was stuck to the adhesive strip for every single piece. I had to fight with nails, razor blade etc, to try to peel off the non-stick film to expose the sticky part, and in doing so I ripped off the adhesive multiple times. I'm fairly patient and delicate - this is just really poor quality adhesive (maybe it's due to improper storage at warehouse? no idea). Also, the length is misleading, as these come in 17" parts. So you'll be attaching many of them in series ... it's hard to line these up perfectly in a tight corner, so you're bound to get a few slightly off and it won't look like a clean gapless line. Similarly putting the cover on by sliding it is not fun, because you'll have to slide it through multiple pieces of this thing that you've attached to the floor, and due to the aforementioned gaps some may not slide over easily. I shoved them over instead of sliding them - it takes some fussing around but it works. I got the small size and it was VERY snug for a single cable power strip (if you have a higher amp power strip with thicker cable then this may or may not fit in size small).

This came with a decent amount of where I could use it for multiple rooms hiding cords for different reasons. I used this at home and at my studio for work. Easy to apply, has a clean look, and good quality with cord protection